Volume 18, Issue 2 (June 2021)
Abstract
(11722 Views) |
Full-Text (PDF)
(4588 Downloads)
|
Graphical Abstract
|
Highlights
- The introduction of a gas via a bubble stream into a melt is a novel and safe method for the study of the early stages of surface film formation without the complicating issue of exposed melt contamination in furnaces. The technique would need some improvements to be reliable at very low oxygen partial pressures.
- Characterization of the initial surface films on molten AZ91D and AM60B alloys were investigated in non-isothermally state under reactive (dry air, SF6 and HFC-134a) and non-reactive (UPH Argon) atmospheres by SEM and EDS techniques.
- Effect of Al element as a reactive surface element on oxidation and fluoridation behavior of the molten Mg alloy was studied.
- A comparatively study has been done in this research so that a rough and folded surface film morphology in Mg-Al alloy is compared to thin and fine wrinkled oxide film under dry air in molten pure Mg alloy.
Abstract
(17578 Views) |
Full-Text (PDF)
(5631 Downloads)
|
Graphical Abstract
|
Highlights
- The type of heat treatment has a significant effect on the hot flow behavior of AA6061 and AA6063 aluminum alloys.
- The heat treatment effects on the flow behavior of AA6061 are more than AA6063 alloy.
- The heat treatment effects on the thermomechanical behavior of both alloys decrease with increasing temperature.
- The type of heat treatment has a lesser effect with increasing deformation temperature.
- The work hardening rates are higher for aged aluminum alloys compared to annealed ones.
- The volume fraction of precipitations decreases with increasing deformation temperature.
Abstract
(17170 Views) |
Full-Text (PDF)
(4430 Downloads)
Abstract
(14127 Views) |
Full-Text (PDF)
(4613 Downloads)
Abstract
(16457 Views) |
Full-Text (PDF)
(8726 Downloads)
Abstract
(15071 Views) |
Full-Text (PDF)
(4499 Downloads)
Abstract
(14445 Views) |
Full-Text (PDF)
(5502 Downloads)
Abstract
(18378 Views) |
Full-Text (PDF)
(4767 Downloads)
|
Graphical Abstract
|
Highlights
- The low velocity impact (LVI) response of pure and GFRPs containing various loading of SWCNTs was investigated using the drop-weight impact machine
- The absorbed energy of incorporated GFRP with different weight percent of SWCNT was studied.
- LS-DYNA numerical explicit finite element code was used to simulate the impact process of neat and incorporated GFRP with functionalized SWCNT.
- Experimental and numerical LVI test results were compared in the terms of maximum contact force and back-face damage area of specimens.
Abstract
(16488 Views) |
Full-Text (PDF)
(4676 Downloads)
Abstract
(11269 Views) |
Full-Text (PDF)
(9029 Downloads)
Abstract
(20129 Views) |
Full-Text (PDF)
(4779 Downloads)
Abstract
(15977 Views) |
Full-Text (PDF)
(4829 Downloads)
Export as:
HTML
|
XML
|
RSS